Volantex RC ASW28 V2 2.6m Plastic Unibody Scale Glider-- PNP

The Volantex ASW 28 is a sport scale model that does incorporate flaps unlike its full-scale counterpart. It comes plug and fly so you just need to complete some final assembly, install your battery, receiver and fly. The airframe is a mix of EPO foam for the wings and tail, with a blow molded plastic fuselage. This gives a slick finish that is also extremely durable. Great for those less than perfect slope sites. A powerful 4018-850kv brushless outrunner motor rockets the ASW 28 to altitude, then when you throttle down, the propeller folds back for extended soaring. Accessing the battery is easy through the canopy with four small snap locks that keeps the canopy secure.

This Version 2 comes with lots of extra features. The wings come with two spars in each wing to give extra strength during those tight turns and power dives. Installing the wings is now easier with a plastic latch for securing the wings. Inside there is now a bigger plywood tray to make it easier to carry FPV camera's, VTx's or other electronics. Landings are now a lot easier with the inclusion of landing gear. No more scraping the fuselage.

Features:
• Plug and Fly - Just install your own battery, transmitter and receiver
• Ultra durable blow molded plastic fuselage
• EPO foam molded wings and tail
• All servos, including flaps come pre-installed
• Easy removal canopy/battery hatch with pilot figure
• Powerful 4018-850kv brushless motor with folding propeller

Specs:
Wingspan: 2600mm (102.4")
Length: 1132mm
Flying Weight: 1050g
Motor: 4018-850kv Brushless Outrunner Motor
ESC: 30A w/BEC 
Servo: 9g x 6 (See all RedwingRC Servos)

Requires:
6 Channel Transmitter and Receiver (Jumper T16) see combo pricing
3S 11.1V 1500mAh Lipoly Battery (see all RedwingRC batteries/chargers) 
Battery Charger: Pulse Balance Charger (PLC100) see combo pricing

Foam-safe glue

$20 Flat Rate Shipping US lower 48 only--contact us at [email protected] to calculate international shipping cost