SBACH 342 3D 6-Axis Gyro Aerobatic Stunt Plane - PNP
SBACH 342 3D 6-Axis Gyro Aerobatic Stunt Plane - PNPThe SBACH 342 3D Aerobatic Stunt Plane is a unique airplane with a 6-axis gyro to provide stabilization on those windy days. With 3 diferent flight modes and the flick of a switch, it can fly vertical 3D hover mode, or switch into airplane 6-axis gyro mode with increaed stability or switch to 3D mode with no gyro or flight control assist. With the High-Efficiency 2205 Brushless Motor, the SBACH 342 features powerful performance for exhilarating 3D fun. This plane comes as a Plug and Play (PNP) with everything needed to fly except for the 6 channel Radio and receiver. The Flight Control System has 2 receiver conversion sockets. One is for Futaba (S-Bus) and other receivers with (S-Bus) ports. The other socket supports DSMX/DSM2 receivers. It is the perfect choice for any RC fan looking to fly extreme 3D stunts yet suitable for beginners wanting to learn 3D flying.
Features:
Specs:
Includes:
Requires:
|
Futaba 6ch FHSS Receiver
Flight controller showing both FHSS and DSMX ports
HUBSAN X4 107L RTF
HUBSAN X4 107L This quadcopter is Ready-To-Fly right out of the box. Suitable for indoor and outdoor flying. The 6-axis flight control system allows the Hubsan X4 to maintain stable flight even in light wind conditions.
Meet the Hubsan X4 Setup and Operation
Promo Video
|
Hubsan X4-
$39.99
BMS-2109, HV-DIGITAL, HIGH TORQUE, ULTRA HIGH SPEED, CORELESS, TITANIUM GEARS
BMS-2109, HV-DIGITAL, HIGH TORQUE. HIGH SPEED, CORELESS, TITANIUM GEARS |
BBR-BMS-2109
$50.00
Bob Smith Industries 304 Pocket CA Extender Tips for Pocket CA Tops (6 Pack)
Bob Smith Industries 304 Pocket CA Extender Tips for Pocket CA Tops (6 Pack) UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure on plastics. Separating plastics parts with a razor saw is usually the best option. Un-Cure™ will soften cured super glue (aka cyanoacrylate, CA). To release bonded skin (not near the eyes) apply Un-Cure™, then use a small, rounded object like a paperclip to separate the skin with a peeling action, applying more Un-Cure™ as needed until the skin areas are debonded. Wash the area with soap and water. The natural shedding of the skin’s outer layer will remove any residual CA within 12 hr. For removing CA from hard surfaces, soak a cloth or paper towel in Un-Cure™ and rub areas vigorously. Un-Cure™, however, will mar most plastics.
Works Best On:
Avaliable in 1 oz Size.
|
BSI-304
$2.99