Volantex RC ASW28 V2 2.6m Plastic Unibody Scale Glider - PNP

Contact UsCustomer Reviews

Volantex RC ASW28 V2 2.6m Plastic Unibody Scale Glider - PNP

Our Price:

$199.99


Extra Prop/Spinner
Quantity (1)

Availability 1 in stock
Weight 5.00 lbs
SKU ASW28

Volantex RC ASW28 V2 2.6m Plastic Unibody Scale Glider-- PNP

The Volantex ASW 28 is a sport scale model that does incorporate flaps unlike its full-scale counterpart. It comes plug and fly so you just need to complete some final assembly, install your battery, receiver and fly. The airframe is a mix of EPO foam for the wings and tail, with a blow molded plastic fuselage. This gives a slick finish that is also extremely durable. Great for those less than perfect slope sites. A powerful 4018-850kv brushless outrunner motor rockets the ASW 28 to altitude, then when you throttle down, the propeller folds back for extended soaring. Accessing the battery is easy through the canopy with four small snap locks that keeps the canopy secure.

This Version 2 comes with lots of extra features. The wings come with two spars in each wing to give extra strength during those tight turns and power dives. Installing the wings is now easier with a plastic latch for securing the wings. Inside there is now a bigger plywood tray to make it easier to carry FPV camera's, VTx's or other electronics. Landings are now a lot easier with the inclusion of landing gear. No more scraping the fuselage.

Features:
• Plug and Fly - Just install your own battery, transmitter and receiver
• Ultra durable blow molded plastic fuselage
• EPO foam molded wings and tail
• All servos, including flaps come pre-installed
• Easy removal canopy/battery hatch with pilot figure
• Powerful 4018-850kv brushless motor with folding propeller

Specs:
Wingspan: 2600mm (102.4")
Length: 1132mm
Flying Weight: 1050g
Motor: 4018-850kv Brushless Outrunner Motor
ESC: 30A w/BEC 
Servo: 9g x 6 (See all RedwingRC Servos)

Requires:
6 Channel Transmitter and Receiver (Jumper T16) see combo pricing
3S 11.1V 1500mAh Lipoly Battery (see all RedwingRC batteries/chargers
Battery Charger: Pulse Balance Charger (PLC100) see combo pricing

Foam-safe glue

$20 Flat Rate Shipping US lower 48 only--contact us at [email protected] to calculate international shipping cost

: *
: *
: *
 

Bob Smith Industries 301 Extender Tips for CA Glue Bottles (6 Pack)

Bob Smith Industries 301 Extender Tips for CA Glue Bottles (6 Pack)

UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure on plastics. Separating plastics parts with a razor saw is usually the best option. Un-Cure™ will soften cured super glue (aka cyanoacrylate, CA). To release bonded skin (not near the eyes) apply Un-Cure™, then use a small, rounded object like a paperclip to separate the skin with a peeling action, applying more Un-Cure™ as needed until the skin areas are debonded. Wash the area with soap and water. The natural shedding of the skin’s outer layer will remove any residual CA within 12 hr. For removing CA from hard surfaces, soak a cloth or paper towel in Un-Cure™ and rub areas vigorously. Un-Cure™, however, will mar most plastics.

 

Works Best On:

  • All Cyanoacrylates

 

Avaliable in 1 oz Size.

 

 

Click to Download Safety Data Sheet

BSI-301

$2.99

Phoenix 2400 (2.4M) Professional Grade Glider (PNP)

Phoenix 2400 (2.4M) Professional Grade Glider (PNP) 

*Free shipping is for continental US only

RedwingRC Plug-and-Play aircraft!

Now this is a unique plane for sure! Upgrade that asphalt runway of yours to a pond, lake or pool! The PBY Catalina seaplane is something you have to experience! It took months of flight testing and designing to produce this amazing aircraft. The Catalina is capable of stable flight at really slow speeds making it perfect for any skill level. Get ready for some really neat details and a large 55 inch wingspan! The Catalina is blast to fly and and landing on on water is a piece of cake.

Key Features:

  • Powerful twin 480 size (1100kv) outrunner brushless power system w/ 3-bladed props
  • Twin 30A Brushless ESC with Switch-Mode BEC
  • Durable and lightweight EPO construction with many surface details
  • Excellent Flight Performance
  • Detailed Body Structure
  • Suitable for Both Intermediate and Experienced Pilots.
  • Removable / detachable wing. (4 screws)

 

Specifications:

Wingspan: 58 inches / 1470mm
Overall Length: 37 inches / 940mm
Flying Weight: 45oz  / 1275 w/Battery
Motor Size: Twin 480 size (2814-1100kv) outrunner brushless motors (installed)
Propeller: 2 x 3 blade props 8 x 6 x 3
Radio / Transmitter 4 Channel (NOT INCLUDED)
Receiver +4 Channel (NOT INCLUDED)
Servos: 4 servos installed ( 2 x 9g - 2 x 17g)
Speed Control : 1 x Dectrum 30A Brushless with Switch-Mode BEC (installed)
Battery: 11.1V 2200 mah (not included)
Charger: 3S+ (11.8v) Lipo Charger (NOT INCLUDED)
Flight Times

Average (8-12 mins)

Assembly Time

Approx 45min

 

 

 


 

Phoenix-2400-759-3

$219.99

Power HD A-50 HV Coreless High Torque 50.0 kg/ 694.4 oz 0.16 sec 8.4V (Programmable, for 30-200CC Airplane or Jet)

Power HD A50 Coreless HV High Torque 50.0 kg/ 694.4 oz 0.16 sec 8.4V (Programmable, for 30-200CC Airplane or Jet)

Thought our other servos were great? Well of course they are! But wait until you check out these new Power HD servos - they will rock your wheel pants off* (no wheel pants will be harmed by using this product - but you get the idea).

There's a storm brewing in Redwing RC! These new HD Storms can handle anything thrown at them. Now, we can't imagine your servos heading into battle facing a hurricane or tornado - but they sure behave as if they have fought and conquered the fiercest of storms - taking all of that power and knowledge with them when they are installed into your bird. Rain or shine, these servos are ready for anything!

The HD Storm 3s are high efficiency and perform better. They run cooler and quieter and with less vibration - because there are no brush arcings, the radio frequency interference and electronic noise is significantly reduced.

All aluminum housing, high voltage and the new brushless technology gives you the best strength and speed while being incredibly efficient and long lasting.

New and Improved Technology!

The Power HD Storm 3 high voltage servos are made with brushless technology. Now - we've heard about this "brushless" stuff before but it is time to ask the question on all of our minds - why is that so great? Take a brushless motor for example - no brushes in a brushless motor (no kidding...) nor does it have the commutator - instead a small circuit board coordinates the energy delivery to the windings. Think about this technology being used in a power tool - since the electronics communicate directly with the stationary windings the tool can adapt to its surroundings - only using enough juice necessary to accomplish the job. So if you are using a brushless drill to drive a screw into Styrofoam - it will sense the lack of resistance from the foam and pulls only enough charge from the battery that it needs. Whereas a brushed drill will run as fast and hard as it can no matter the job simultaneously wasting your battery life.

"What the heck does that have to do with my servo?" Well now they are incorporating that smart technology into these HD Storm 3 high voltage servos - so they are not going to be sucking the life of your Redwing LiFe battery when it doesn't have to - which means not only would you be getting a great and powerful servo - it's smart! Your "LiFe" will thank you.

Perfect for Giant Scale/3D planes and 1/5 Buggy/Crawler! So now the only question is - why are you still reading this? Go buy your Power HD Storm 3 servos before they're gone!

Specs:

  • Torque:
    • 374.9 oz/in at 6V (27.0 kg/cm)
    • 444.4 oz/in at 7.4V (32.0 kg/cm)
       
  • Speed:
    • .14 sec at 6VV
    • .11 sec at 7.4V
       
  • Voltage: 6.0 ~ 8.4 V
  • Weight: 2.82 oz (80g)
  • Size: 1.57 x 0.79 x 1.53 in (40.0 x 20.0 x 38.0mm)
     
  • Operating Temp- -20~60centigrade
  • Working Frequency - 1520μs / 333hz
  • BRUSHLESS Motor
  • Double Ball Bearings
  • Titanium and Steel gears
  • Water resistant O-Rings

 

HD-A50

$89.99