Mejzlik 2 Blade Carbon Fiber Props
Mejzlik Carbon props are the most popular props for many top RC pilots. Mejzlik’s props promote higher performance and lower noise levels. Designed with many years experience and the latest in aerodynamic and composite technologies and cooperation with professionals from top research and universities in the Czech Republic. Mejzlik’s props are made only from high quality carbon fabric and rovings and filled with epoxy resin. Select your size prop. |
Dynam Carbon Fiber Electric Props
Description:
|
TC-EP-
$15.99
BMS-2109, HV-DIGITAL, HIGH TORQUE, ULTRA HIGH SPEED, CORELESS, TITANIUM GEARS
BMS-2109, HV-DIGITAL, HIGH TORQUE. HIGH SPEED, CORELESS, TITANIUM GEARS |
BBR-BMS-2109
$50.00
Bob Smith Industries 304 Pocket CA Extender Tips for Pocket CA Tops (6 Pack)
Bob Smith Industries 304 Pocket CA Extender Tips for Pocket CA Tops (6 Pack) UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure on plastics. Separating plastics parts with a razor saw is usually the best option. Un-Cure™ will soften cured super glue (aka cyanoacrylate, CA). To release bonded skin (not near the eyes) apply Un-Cure™, then use a small, rounded object like a paperclip to separate the skin with a peeling action, applying more Un-Cure™ as needed until the skin areas are debonded. Wash the area with soap and water. The natural shedding of the skin’s outer layer will remove any residual CA within 12 hr. For removing CA from hard surfaces, soak a cloth or paper towel in Un-Cure™ and rub areas vigorously. Un-Cure™, however, will mar most plastics.
Works Best On:
Avaliable in 1 oz Size.
|
BSI-304
$2.99