HUBSAN X4 107L
RTF (2.4ghz 4 channel radio included!)!



Say hello to the newest member of the RedwingRC family. The Hubsan X4 Quadcopter!!

This quadcopter is Ready-To-Fly right out of the box. Suitable for indoor and outdoor flying. The 6-axis flight control system allows the Hubsan X4 to maintain stable flight even in light wind conditions.

Meet the Hubsan X4

Setup and Operation

Promo Video


 

Features:

• Measures-  2.3 x 2.3 x 1.2 inches at 1.1 pounds
• Latest 6-axis flight control system with adjustable gyro sensitivity
• Permits super stable flight. With 4 channels
• Lightweight airframe with nice durability
• 4-ways flip (left, right, forward, and backward)
• Upgraded with 4 LED night lights
• 4 channels and operates at 2.4 GHz.

• Battery voltage: 3.7V
• Capacity: 240mAh
• Flight time: above 9 minutes
• Charging time:30 minutes
• Flying range of about 30 meters / 98 feet
• USB charging ability, you can charge it from your computer! How cool is that!?
   

BMS-2109, HV-DIGITAL, HIGH TORQUE. HIGH SPEED, CORELESS, TITANIUM GEARS

Bob Smith Industries 304 Pocket CA Extender Tips for Pocket CA Tops (6 Pack)

UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure on plastics. Separating plastics parts with a razor saw is usually the best option. Un-Cure™ will soften cured super glue (aka cyanoacrylate, CA). To release bonded skin (not near the eyes) apply Un-Cure™, then use a small, rounded object like a paperclip to separate the skin with a peeling action, applying more Un-Cure™ as needed until the skin areas are debonded. Wash the area with soap and water. The natural shedding of the skin’s outer layer will remove any residual CA within 12 hr. For removing CA from hard surfaces, soak a cloth or paper towel in Un-Cure™ and rub areas vigorously. Un-Cure™, however, will mar most plastics.

Works Best On:

• All Cyanoacrylates

Avaliable in 1 oz Size.

Click to Download Safety Data Sheet