Bob Smith Industries Foam-Cure
Untitled Document Description:Bob Smith Industries Foam Cure Foam-Cure™FOAM-CURE™ is a silicone based adhesive that works very well on EPP and EPO foams. It is crystal clear and cures to a more flexible consistency than CA. It is, however, not instant bonding like CA and there is no accelerator to speed it’s curing. To obtain a faster initial bond when bonding two pieces, FOAM-CURE™ can be applied to one piece and after the two are joined, they can then be pulled apart. After letting it air dry for about ten minutes, FOAM-CURE™ will act like a contact cement when the parts are rejoined, resulting in enough tack strength to allow the next steps of assembly. Full strength is reached in 10-12 hours. FOAM-CURE™ works with all foams, and will actually bond most other materials. It will bond wood and plastic to foam, and is a good canopy glue. FOAM-CURE™ does not, however, cure flexible enough to act as a hinge for aircraft control surfaces. Its limitations occur when bonding large areas of two non-porous materials. FOAM-CURE™ requires exposure to air for drying. If one tried to bond, for example, a half-dollar coin to glass, over 90% of the adhesive would never cure, since the solvent it contains would have no where to evaporate. A small amount of denatured alcohol can be mixed into the Foam-Cure to make it thinner.
Works Best On:
Cut off tip of nozzle. Apply to one part before joining. Use tape to hold parts in place during cure. For faster curing, pull the joint apart and let Foam-Cure™ air dry for 5-10 min before rejoining the parts. This results in enough tack strength to allow the next steps of assembly. Full cure takes 10-12 hours. Foam-Cure™ works on all foams, especially on EPP and EPO, and will bond a porous surface to non-porous materials. Foam-Cure™ is also an excellent glue for clear canopies, and will also bond paper. If needed, denatured alcohol can be used to thin or clean up uncured Foam-Cure™. Replace cap after use.
Click to Download Safety Data Sheet
|
LiFe Batteries 2S
| Description:
Be sure to select the XT connector if purchasing for use with our Power Box PRO's. Please select connector type: Deans or XT.
|
LiFe
$18.99
Miracle CNC Heavy Duty Half Servo Arm 1.25-1.5" and 1.75-2" (Futaba/Hitec/JR)
| Miracle CNC Heavy Duty Half Servo Arm 1.25-1.5" and 1.75-2" (Futaba/Hitec/JR) |
MRC-F-024-Servo-Arm
$12.99
BMS-127+ MICRO WIDE VOLTAGE-DIGITAL, HIGH SPEED, CORELESS SERVO (5.3kg/73.7oz 0.05sec 8.4V)
BMS-127+ MICRO WIDE VOLTAGE-DIGITAL, HIGH TORQUE, CORELESS SERVO (5.3kg/73.7oz 0.05sec 8.4V) |
BBR-BMS-127WV+
$23.99
