Heng Long Abrams US M1A2 V7 1/16 RC Tank (RTR)
Heng Long Abrams US M1A2 V7 1/16 RC Tank (RTR)The M1 Abrams, officially commissioned by the US military in 1980, was designed totally different from previous post-WWII US military tanks. Although fitted with the same 105mm cannon as the M60, the M1 was powered by a gas turbine engine and was fitted with spaced armour. Planned to be commissioned by the US military over a long period, the M1 was designed with future reforms in mind. In 1984, the M1A1 was developed with a 120mm smooth bore cannon, and a further variant the M1A1HA was later developed featuring depleted uranium armour. This then led to the M1A2, which was fitted with Intervehicular Information System (IVIS), Commander's Independent Thermal Viewer (CITV) turret and new style vision block. The M1A1HA and the M1A2 both played significant roles in Operation Iraqi Freedom, being deployed by land forces as well as the Marine Corps as they moved toward Baghdad. Specifications:
Features:
What's in the box:
Required:
$20 Flat Rate shipping for lower 48 USA only. Contact us at [email protected] for international shipping costs. |
NEW
Redcat Gen8 V2 International Scout II 1/10 4WD RTR Scale Rock Crawler w/2.4GHz Radio (Purple)
| Redcat Gen8 V2 International Scout II 1/10 4WD RTR Scale Rock Crawler w/2.4GHz Radio |
BH-65855-Purple
$329.99
Servo Extensions 22AWG and 20AWG
| High quality 22AWG wire, twisted silicone wire extensions. JR type connections, so they will plug into any receiver/switch, and most servos (Hitec/JR/PowerHD/etc etc....futaba you would have to trim the edge off).
|
EX
$2.50
Bob Smith Industries 303 Extra-Long Extender Tips Multi-Use for CAs
| Bob Smith Industries 303 Extra-Long Extender Tips Multi-Use for CAs UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure on plastics. Separating plastics parts with a razor saw is usually the best option. Un-Cure™ will soften cured super glue (aka cyanoacrylate, CA). To release bonded skin (not near the eyes) apply Un-Cure™, then use a small, rounded object like a paperclip to separate the skin with a peeling action, applying more Un-Cure™ as needed until the skin areas are debonded. Wash the area with soap and water. The natural shedding of the skin’s outer layer will remove any residual CA within 12 hr. For removing CA from hard surfaces, soak a cloth or paper towel in Un-Cure™ and rub areas vigorously. Un-Cure™, however, will mar most plastics.
Works Best On:
Avaliable in 1 oz Size.
|
BSI-303
$0.49
Venom DRIVE 35C 3S 5000mAh 11.1V LiPo Hardcase Battery with UNI 2.0 Plug
| Venom DRIVE 35C 3S 5000mAh 11.1V LiPo Hardcase Battery with UNI 2.0 Plug |
VNR15128-RW
$72.99
