High Speed Sponson Racing Boat 495mm (19.5") Hull, Outrigger Shrimp Boat Kit or PNP with water cooled Power System, Shafting/Metal Rudder
High Speed Sponson Racing Boat 495mm (19.5") Hull, Outrigger Shrimp Boat Kit or PNP with water cooled Power System, Shafting/Metal Rudder This classic style Sponson race boat is built from laminated plywood and beautifully finished. It has two removable hatch panels that make accessing electronics and swapping batteries a breeze. It also features lightweight, extremely rigid carbon fiber sponson boom supports. This boat comes in 2 versions; Kit or Plug and Play (PNP). As a kit, you will need to add your own hardware such as rudder, propeller shaft/mount, propeller and electronics. As PNP, the power accessories are included except still requires the battery, charger and 2CH radio system (Transmitter/Receiver). Watch videos to see this super fast boat in action! Specifications:
Recommended Setup:
Versions available (use drop down to select):
|
Servo Extensions 22AWG and 20AWG
| High quality 22AWG wire, twisted silicone wire extensions. JR type connections, so they will plug into any receiver/switch, and most servos (Hitec/JR/PowerHD/etc etc....futaba you would have to trim the edge off).
|
EX
$2.50
Bob Smith Industries 303 Extra-Long Extender Tips Multi-Use for CAs
| Bob Smith Industries 303 Extra-Long Extender Tips Multi-Use for CAs UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure on plastics. Separating plastics parts with a razor saw is usually the best option. Un-Cure™ will soften cured super glue (aka cyanoacrylate, CA). To release bonded skin (not near the eyes) apply Un-Cure™, then use a small, rounded object like a paperclip to separate the skin with a peeling action, applying more Un-Cure™ as needed until the skin areas are debonded. Wash the area with soap and water. The natural shedding of the skin’s outer layer will remove any residual CA within 12 hr. For removing CA from hard surfaces, soak a cloth or paper towel in Un-Cure™ and rub areas vigorously. Un-Cure™, however, will mar most plastics.
Works Best On:
Avaliable in 1 oz Size.
|
BSI-303
$0.49
Venom DRIVE 35C 3S 5000mAh 11.1V LiPo Hardcase Battery with UNI 2.0 Plug
| Venom DRIVE 35C 3S 5000mAh 11.1V LiPo Hardcase Battery with UNI 2.0 Plug |
VNR15128-RW
$72.99
