Hero/Rescue 4CH RC Helicopter W/ Automatic Stabilization System -RTF (SWAT, Sheriff, Police and Coast Guard)
Hero/Rescue 4CH 100 Size Scale RC Helicopter W/ Automatic Stabilization System - PRO Version RTF (SWAT, Sheriff, Police and Coast Guard)Pre-order sale $40 off! Estimated Arrival late Sep 2023
Credit Card or other payment will be charged at the time of order--Reserve yours today! The Hero-Copter is the next Rage RC helicopter that takes the ease of flying a micro heli to a whole new level. This new scale-like heli is equipped with all the features that make RC drones easy to fly, such as 6-axis flight control, auto take-off and land, altitude hold, plus three flight modes (beginner, intermediate, and advanced) that make it fun to fly for pilots of all skill levels. A coreless main motor provides plenty of power and 2-gram digital servos provide precision and responsive control. The Hero-Copter provides long flight times of over 15 minutes due to the safe, convenient 2S 350mAh plug-in battery so you can maximize your flying time indoors (in appropriately sized spaces) or outdoors in little to no wind. Features:
Specifications:
Requires:
|
Servo Extensions 22AWG and 20AWG
| High quality 22AWG wire, twisted silicone wire extensions. JR type connections, so they will plug into any receiver/switch, and most servos (Hitec/JR/PowerHD/etc etc....futaba you would have to trim the edge off).
|
EX
$2.50
Bob Smith Industries 303 Extra-Long Extender Tips Multi-Use for CAs
| Bob Smith Industries 303 Extra-Long Extender Tips Multi-Use for CAs UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure on plastics. Separating plastics parts with a razor saw is usually the best option. Un-Cure™ will soften cured super glue (aka cyanoacrylate, CA). To release bonded skin (not near the eyes) apply Un-Cure™, then use a small, rounded object like a paperclip to separate the skin with a peeling action, applying more Un-Cure™ as needed until the skin areas are debonded. Wash the area with soap and water. The natural shedding of the skin’s outer layer will remove any residual CA within 12 hr. For removing CA from hard surfaces, soak a cloth or paper towel in Un-Cure™ and rub areas vigorously. Un-Cure™, however, will mar most plastics.
Works Best On:
Avaliable in 1 oz Size.
|
BSI-303
$0.49
Venom DRIVE 35C 3S 5000mAh 11.1V LiPo Hardcase Battery with UNI 2.0 Plug
| Venom DRIVE 35C 3S 5000mAh 11.1V LiPo Hardcase Battery with UNI 2.0 Plug |
VNR15128-RW
$72.99
