Products Map - RedwingRC.com

31.5" EPP 3D Airplane YAK55 Features: • Kit version - Assemble and install your choice of electronics • All hardware accessories included in kit • Durable EPP material with realistic printing resemblance of a shark • Simple to build Specification: Wingspan: 800mm Length: 875mm Flying Weight: 400g Suggested Power System: Motor: 2212 1400KV ESC: 20A Servo: 9g *4 Propeller: SF 8-9inch Radio: more than 4CH BATT: 2S 1200-1500mAh (Not incl.) Different versions supplied as below: E1701=E17 YAK55 KIT+APC SF9047 E1702=E17 YAK55 KIT+Motor(2212 1400KV+3.5mm Banana Male Plug+3.0mm Prop Adapter) E1704=E17 YAK55 KIT+Motor+ESC(20A E-Power+3.5mm Banana Female Plug+XT60 Plug)+Servo(9g*4)

Jambo XP 1/8 Monster Truck, SWB 4WD 6S Brushless RTR 

Jammin Sport Kite Black

Jammin Sport Kite Red/Black

Jetpack Commander Night Ranger RTF Quad

The Jetstar Pro EDF Jet takes you to the next level of performance. The 11-Blade 64mm EDF will give you the power to burn as well as that realistic jet sound. As it is only 940mm long it will be easy to transport to the nearest flying field.

Made of strong EPO foam and a quality build this jet will soar through the air. Build time is kept to a minimum as servos, motor, ESC and EDF are pre-installed. Its great looks and sleek lines are enhanced by the factory fitted decals. The large battery hatch will make installing the receiver (not supplied) and battery (not supplied) a breeze. It comes with a steerable nose wheel to provide better ground handling.

Once in the air, there is plenty of power with a 1:1.2 thrust rate provided by the 4S EDF system. This will make all aerobatics and fast low-level passes just so easy. It comes with a rudder so you should be able to try a few knife edges. This plane is built to fly.

Features:
• Made of strong EPO foam
• Plug-in wings with strong magnets for fast assembly and the ability to fly at high speed
• Motor, EDF, Servos, and ESC are factory pre-installed
• Large canopy for easy battery access and RC installation
• 11-blade EDF produces a realistic “Whooshing” gas turbine jet sound
• Factory-applied decals

Specs:
Wingspan: 800mm (31.5”)
Length: 915mm (36.0")
Flying weight: 900-1000g
Thrust rate: 1:1.2
Motor: D2839-3300kV
EDF: 64mm (11-blades)
ESC: 60A Brushless
Servo: 4 x 9g plastic gear, 1 x 9g metal gear on elevator
Flight time: 5 mins (approx)

Required:
1 x R/C Radio System (T/RX)
1 x 2200mAh 4S LiPo battery

JR Jump Wire

Description:
Our 6” heavy-duty Y-harnesses are perfect for standard servos up to 1/4 scale servos. They offer 22awg wire, gold plated connectors and thick wire jackets. Y-junction located in the middle of the harness and is a solid plastic housing rather than the cheaper heat shrink Ys.

Perfect for getting 2 leads out of one RX port.

1 servo Y per unit:

JR wire split to individual +, -, and signal

JST to 4mm Banana Plug Battery Charge Cable

Description:

Male Deans to Male XT60 Connector

With this Deans to XT connector you can convert a battery with T-Plug to XT-60 on ESC / charger
The connector has many applications and can be used for charger adapter.

Features:

• Male Deans T style plug to Male XT60
• Durable design
• Heatshrink seal

JST-XH 2-6S Lipo Battery Charger Balance Board

This Paraboard lets you charge and balance up to six lipo batteries at once! This board features Traxxas connectors for your batteries' main leads and JST-XH balance plugs ranging from 2S to 6S. They plug right into most popular models of 6S lipo balancing chargers that have 7-pin balance ports with 2.5mm pin spacing.

To get the most out of your Paraboard, pick up one of our GT-400 chargers. It provides 400W of total charging power and charge rates of up to 20 amps! This paraboard has a maximum charge rate of 30 amps.

Battery packs must be of the same cell count (only charge 2S with 2S, 3S with 3S, etc.) and battery voltages must be within 0.1V per cell (0.1V for 1S, 0.2V for 2S, etc.) of all other batteries connected to the Paraboard at the same time. Use a Cell Spy or similar voltage tester to check the voltage of each cell before connecting to the Paraboard.

JST-XH and ThunderPower (TP) 2-6S Balance Board

This Paraboard lets you charge and balance up to six lipo batteries at once! This board features Traxxas connectors for your batteries' main leads and JST-XH balance plugs ranging from 2S to 6S. They plug right into most popular models of 6S lipo balancing chargers that have 7-pin balance ports with 2.5mm pin spacing.

To get the most out of your Paraboard, pick up one of our GT-400 chargers. It provides 400W of total charging power and charge rates of up to 20 amps! This paraboard has a maximum charge rate of 30 amps.

Battery packs must be of the same cell count (only charge 2S with 2S, 3S with 3S, etc.) and battery voltages must be within 0.1V per cell (0.1V for 1S, 0.2V for 2S, etc.) of all other batteries connected to the Paraboard at the same time. Use a Cell Spy or similar voltage tester to check the voltage of each cell before connecting to the Paraboard.